(SUB-1710) Subaru Impreza MX Series Lower Grille Installation Details

(SUB-1710) Subaru Impreza MX Series Lower Grille

Products : SUB1710B , SUB1710S

Install Step #1:
The GrillCraft Mesh Sport Grille Kit Part# SUB 1710 is available in Silver & Black finishes.
Install Step #2:
Here is our project Subaru in need of a GrillCraft Mesh Sport Grille.
Install Step #3:
Notice the stock vehicle has no A/C condenser or radiator protection in place. The GrillCraft Sport Grille will fix this problem and at the same time ad styling to your vehicle.
Install Step #4:
Start by opening the hood and locate the bumper reinforcement bolts.
Install Step #5:
Remove the bumper reinforcement bolts located on the topside of the frame rails there are two on each frame rail.
Install Step #6:
Remove the center bolt located in the bumper opening. (This bolt will no longer be used do to accessibility once grille is in place)
Install Step #7:
Remove lower bolts securing underside cover.
Install Step #8:
Remove bumper clips located in the wheel well opening as shown.
Install Step #9:
Remove bumper clip that secures the bumper cover end to the fender as shown.
Install Step #10:
Now the bumper is ready to slide off the vehicle. Keep in mind just to slide it off far enough to gain access to the lamp plugs.
Install Step #11:
Disconnect the turn signal and driving lamp connection plugs.
Install Step #12:
With the bumper off the vehicle place grille into bumper opening.
Install Step #13:
While holding the grille firmly in place using a scribe mark the mounting tab center hole location
Install Step #14:
Close look at marking center mounting tab location.
Install Step #15:
Using a 3/16-drill bit drill the side tab mounting screw location.
Install Step #16:
Using a 3/16-drill bit drill the center tab mounting screw location.
Install Step #17:
Install the center screw with the supplied fasteners as shown. It is best to start on the center screw first then the sides
Install Step #18:
Install the side screws with the supplied fasteners as shown then install bumper onto vehicle.
Install Step #19:
Wow what a difference great styling with added protection to you're a/c condenser from road debris.
Install Step #20:
Ready for any road rally or just cruzin the blvd.
Install Step #21:
Now the vehicle looks finished without the big bare opening.
Install Step #22:
The fit and finish only GrillCraft could offer.

These installations steps pertain to the following vehicles:


Year Make Model Submodel Fitment Notes
2001 Subaru Impreza RS N / A
2001 Subaru Impreza RS N / A
2001 Subaru Impreza RS N / A
2001 Subaru Impreza RS N / A
2000 Subaru Impreza RS N / A
2000 Subaru Impreza RS N / A
1999 Subaru Impreza RS N / A
1999 Subaru Impreza RS N / A